qatarneh

Members
  • Content count

    5
  • Joined

  • Last visited

Community Reputation

-1 Poor

About qatarneh

  • Rank
    Newbie
  • Birthday 11/25/84

Contact Methods

  • MSN
    tareq.qatarneh@hotmail.com
  • Website URL
    http://
  • Skype
    tareq.qatarneh

Profile Information

  • Gender
    Male
  • Location
    Amman-Jordan
  1. Yes there is special license required for failover on ASA 5510, Older versions of adaptive security appliance software required that the licenses match on each unit. Starting with Version 8.3(1), you no longer need to install identical licenses. Typically, you buy a license only for the primary unit; for Active/Standby failover, the secondary unit inherits the primary license when it becomes active. If you have licenses on both units, they combine into a single running failover cluster license.
  2. Dears, I am going to Configure the Failover, between 2 of ASA's, Active/Standby Failover. Each ASA have 3 DMZ's, one of them on ethernet 0/0 "OUTSIDE", and two of them on ethernet 0/1 "Subinterface". So each ASA must have 3 cables, two of them on switch, and one of them point to point between ASA's. The general configuration: ASA01: interface Management0/0 description LAN/STATE Failover Interface failover failover lan unit primary failover lan interface fail Management0/0 failover link fail Management0/0 failover interface ip fail 192.168.128.1 255.255.255.252 standby 192.168.128.2 ASA02: interface Management0/0 description LAN/STATE Failover Interface failover failover lan unit secondary failover lan interface fail Management0/0 failover link fail Management0/0 failover interface ip fail 192.168.128.1 255.255.255.252 standby 192.168.128.2 ----------------------------------------------------------------------------------------------------- So this we will work successfully !!! If you have an opinion or idea, please send. Regards,
  3. Dears, I will start, understanding the configuration and setup of MPLS, so any hints will help me in this, and if you have any basic setup & scenarios of MPLS "L2, L3 & VPLS" Regards, Tareq
  4. Dears, I established an IPv6 GRE Tunnel on Juniper Router MX, everything going well, till I applied a firewall access-list on interface loopback 0. I needs to allow GRE packets from Source Address to Destination Address and open the GRE tunnel port on the firewall filter "XXXXX". How this could be done ? Regards. Tareq
  5. Hi everyone ,,, This is the first Topic for me ,,, Maybe someone can help me ,,, I need to know , how can i create a report to show all VPN Session that is connected to our ASA Firewall ,,, and in this report i need to show "Info/SuccessfulLogin/PPP, Info/SuccessfulLogin/SSLVPN, Info/SuccessfulLogin/IPSec, Cisco IPSec VPN user disconnected, IPSec User authenticated, IPSec User authenticated., IPSec User authenticated., IPSec User authenticated., Terminating IPSec connection". And the most important thing is to show the duration of connection, i mean when the connection starts and when the connection is "stopped or disconnect". Thank you all for your help ,,, qatarneh ,,,