6 replies to this topic

[dklman]

Help Please,

Finally got the ASA to work, now hwen I try to save my config using wr -m or copy run start. I get not enough space to save config. Any and all help would be greatly appreciated

[VENERZKY]

I'm having the same issue. Any workaround?

[VENERZKY]

Below is the output error.



ciscoasa(config)# boot config disk0:/.private/startup-config
ERROR: Unable to set this url, file has non-ASCII characters

[VENERZKY]

Help Please,

Finally got the ASA to work, now hwen I try to save my config using wr -m or copy run start. I get not enough space to save config. Any and all help would be greatly appreciated

Saving ASA Configuration
========================

1st command
ciscoasa# copy running-config disk0:/.private/running-config

2nd command
ciscoasa# copy disk0:/.private/running-config disk0:/.private/startup-config

3nd command
ciscoasa# configure terminal
ciscoasa(config)# boot config disk0:/.private/startup-config
ciscoasa(config)# exit

[laf_c]

Nice work mate; 10x for sharing !!

[VENERZKY]

Nice work mate; 10x for sharing !!

no problem

[firewallengineer]

Saving ASA Configuration
========================

1st command
ciscoasa# copy running-config disk0:/.private/running-config

2nd command
ciscoasa# copy disk0:/.private/running-config disk0:/.private/startup-config

3nd command
ciscoasa# configure terminal
ciscoasa(config)# boot config disk0:/.private/startup-config
ciscoasa(config)# exit

Thanks VENERZKY for the info. My approach is slightly different, but it works as well.

enable
config t
copy run disk0:/.private/startup-config
boot config disk0:/.private/startup-config
wr mem

I've also documented it here. I hope this helps.
http://firewallengin...cii-characters/