4 replies to this topic

[blackrose21]

Hi,

As per CISCO QoS document (http://www.cisco.com... ... #wp1029406) IOS from 12.2(13)T support drop command in policy map. But our CISCO ASR 1013 having IOS of Version 15.2(1)S1 doesn't have drop syntax.

1. How can we drop specific application using QoS in ASR 1013 of IOS version 15.2 and higher?
2. Can I allow few users for a particular application (like P2P) and drop other users based on users source IP?

[chrcel]

well ASR does not run IOS. it runs IOS-XE look for config guide for IOS-XE instead

[blackrose21]

Dear chrcel,
I am try to rate limit on interface or sub interface. command not found.also try to block voice or vpn.but have some command error.do u have any solution. my IOS SE version is 3.06
(config-if)#rate-limit
^
% Invalid input detected at '^' marker.

(config-subif)#rate-limit
^
% Invalid input detected at '^' marker.

class-map match-all VOICE-VPN
match protocol sip
match protocol rtp
match protocol h323
match protocol skinny
match protocol ipsec
match protocol gre

(config)#policy-map VOICE-VPN
(config-pmap)#class VOICE-VPN
(config-pmap-c)#drop
^
% Invalid input detected at '^' marker.

[chrcel]

how about looking in the documentation?

http://www.cisco.com...uides_list.html

[blackrose21]

Lot of documents.do not found any help.Need help ....