zain2009 0 Report post Posted September 9, 2015 Hi, I want to create a new routing pattern for the SIP trunk, Right now I am using routing pattern of 6[^5]XXX in my CUCM, means except 65XXX series should goes to Nortel system through E1. But now i need to remove 60XXX series from this routing pattern. I am going to use 60XXX as a pattern for SIP trunk. So how to split this route pattern 6[^5]XXX. Anyone can help me to split this routing pattern 6[^5]XXX correctly. Regards AZ. Share this post Link to post Share on other sites
funnyjokes 0 Report post Posted November 19, 2018 Oh! This article has suggested to me many new ideas. I will embark on doing it. Hope you can continue to contribute your talents in this area. Thank you.webnovel Share this post Link to post Share on other sites